EN
25
D - BEGINNING OPERATION
1 - SETTINGS INTERFACE
Indicators
L0
= Green LED switched off when the card is on
standby.
L1 to L5
= Red LEDs to display information
concerning settings, events (or errors) or battery
status.
Buttons
PROG
= Enter or exit settings menus.
“-” / “+”
=
Select an item, set a value, navigate the event log.
SET
= Enter sub-menus, confirm a setting, view the
battery voltage or history of events, enter manual
control.
Important notes:
•
You can do a short press on a button (hold the
button down for less than 1 second) or long press
(hold the button down for 3 seconds). When the
instructions indicate
“
Press the PROG button
”, the button must
be pressed and released. When the instructions
indicate
“Press the
PROG button for 3 seconds”
or “PROG 3s,”
the button must be pressed and held.
•
In the instructions below, the operations to be
performed with the buttons will be described
from
MENU 0
. It’s the display menu that appears
just after the power has been switched on for
example, just after the gate has moved (before
standby) or even when the card is on standby (in
this case, the green LED L0 is switched off).
•
To make sure you are at
MENU 0
of the display,
press
PROG 2 or 3 times and only the green LED
should be switched on.
When the user performs no action on a button
for 15 seconds, the system automatically goes
back to MENU 0.
2 - QUICK SETTINGS
2.1 - MENU STRUCTURE
After it is switched on, the display should
appear as follows (MENU 0)
/
/
/
/
/
/
/
/
/
/
/
/
/
All LEDs are turned off except the green LED
•
If the green LED is not lit, press
PROG
.
•
Lit up green LEDs are an error code
(see paragraph “Event history and error code”).
(Typically, an error code is displayed if the card did
not detect any photocells at the time of power-up.
This does not affect the operation of the card, it is
only for informational purposes).
From here, pressing PROG for 3 seconds
will open the basic settings menu (MENU 1)
•
This menu has 5 items represented by the 5 red
LEDs. When this menu is entered, the red LED L1 is
lit because item 1 is selected by default.
•
Pressing and releasing the “-” and “+” buttons
moves the lighted LED, thus to select 1 item
among the following 5 items:
/
/
/
/
/
/
/
/
/
/
/
/
/
L1
= Self-learning
L2
= Programming/deleting remote control
L3
= Force setting
L4
= Setting the operating mode (semi-automatic
closing, automatic closing, collective mode)
L5
= Delay time before automatic closing
When 1 item is selected (the corresponding red
LED is lit), press SET to:
•
Start an action (self-learning).
•
“Enter” a setting (force setting, operating mode,
time delay).
•
“Enter” a sub-menu (Programming/deleting
remote controls).
This last item is called a sub-menu, because it
contains 3 items (gate command programming,
pedestrian command programming, deletion).
/
/
/
/
/
/
/
/
/
/
/
/
/
•
To go back, for example from the remote control
sub-menu to
MENU 1
, press
PROG
.
•
If you press
PROG
while in
MENU 1
, you exit
completely and return to
MENU
0
.
CONNECTED MOTOR DRIVE KIT