S4 Installation Guide
18
5
Install the connected CSM into the chassis, being careful to orient it correctly and seat it at the front edge of the chassis.
Make sure the module sits completely into the frame and not on any cables.
6
If you are installing an additional CSM in the next chassis, repeat the previous steps.
• If you are not installing a CSM in the next chassis, see “Installing Master Section Modules” on page 19 or “Installing Option
Modules” on page 22 as appropriate for your chassis 2.
• Refer back to these CSM instructions if you are installing one or more additional CSMs.
Figure 7. Channel Strip Module in chassis 1 (cables not shown)
Later, after all modules are in place, they will be secured within their chassis by installing Compression Panels and T-Strips.
Summary of Contents for S4
