50
Installing and Removing the Avid Fan
The documentation that ships with the HP Workstation explains how to install optional
equipment. However, Avid requires an extra fan in the HP Workstation for cooling the Avid
board set. The following procedure describe how to install the fan Avid has added to the HP
Workstation. Reverse the procedure for removing the fan.
c
Before you install or remove the fan, you must make sure the system was turned off in a
proper manner, the power cord is removed from the rear of the system, and you follow
the proper grounding techniques.
To install and remove the fan:
1. Lay the system on its right side.
2. Unlock the left side cover using the keys attached to the rear of the system.
3. Remove the side cover by pulling out the latch to release the cover and removing it from
the system.
4. Place the fan into the two slots located at the rear of the system. Make sure that the
round SCSI cable is under the higher portion of the fan.
Placing the Fan Into the System
Slots
High portion of fan
Round SCSI cable
Summary of Contents for Nitris
Page 58: ...58...
