![background image](http://html.mh-extra.com/html/avery-dennison/zm-110/zm-110_user-manual_3030533021.webp)
AWT35-501813
Issue AA
Page 21
LF-2 CALIBRATION SETTINGS
•
Default setting for calibrating in
kg
with counting function active is [110101]
•
Default setting for Legal-for-Trade calibrating in
kg
is [110001]. Counting function must be
turned off for Legal-for-Trade use.
The calibration steps following the function LF 1 or entering the Calibrations Menu ECF are the same.
For this reason,
only the ECF-1 is described below
.
Before starting, make sure that UF-5 is set as HOLD 0 and Calibration Switch
set to NOT SEALED (see chapter 6.1). Test weights equivalent to at least 1/3
of the maximum capacity are needed.
i.When the scale is ON, press the
and
ZERO
keys together;
ECF-1
will be displayed.
ii.Press
(
↵
) key;
CAL Z
will be displayed;
iii.Remove the loads from the pan (0 kg) and press
(
↵
) to confirm;
iv. Edit the span by pressing
ZERO
(◄) and/or
TARE
(►) keys to move the
flashing digit left or right and press the
SELECT
(▲) key to increase the
numeric value;
v.Press
(
↵
)
to confirm;
vi.
Load the test weight;
vii. Press
(
↵
)
to complete and leave the procedure.
If
Err 10
is displayed re-edit the span value, confirm and move to the
next step.
6.3. Stamped Calibration
For legal for trade applications the following configuration settings need to be set and the indicator seal
according to OIML directives.
• Set the scale division sizes according to the approval document and set the LF6 setting in the
configuration menu to OIML
• (OIML setting represents all the legal for trade setting for both NTEP and OIML)
• Attach the correct capacity labels to the front of the display and seal as shown below
Sealing with supplied tamper proof labels
Sealing with lead seals
For legal for trade applications the indicator has to be properly configured entering the
functions available in the Supervisor Menu before setting the Calibration Switch at OFF
and sealing the indicator.