22
Adjusting the Fastener Cut
If the knife is not centered between two fastener rungs, you must adjust the fasteners position.
1. Loose the nut, screw in or out to adjust the adjusting screw. Then lock the nut after
adjustment.
2. Feed the fasteners and cut, and check if the fasteners are cut properly now at midway.
3. Repeat above step 1 and 2 until the fasteners are cut at the correct position.
Note: Please remember to lock the nut after ultimately adjusted the fastener cutting. As this
machine is using a Non-adjust Feeding System, you do not need to adjust the fastener cutting every time.
Adjusting screw
Nut
Summary of Contents for ST9500
