Avery Dennison ST9500, Operator'S And Service Manual

Page: 16 / 80

16
4.2. Operations in Password Enabled Mode:
a). Press any of the three Buttons of “1”, “2” and “3” at any time in Password Enabled Status,
and the display will show a indication as “XXX” for the user to enter a password. After a valid
password, the user can change the Speed, Interval and Mode parameters, and then press “5” to
confirm.
b). Follow the same procedure as 4.1. b) to enter password.
c). Change the parameters as described in above “3. Button Functions” In this step the settings
will be activated at once after each press of the button and user may run the machine to test the
settings and may change them if necessary. But in this step the settings are not saved to the Flash
Memory and therefore if the power fails at this time, the settings will not be saved.
d). Press Button “5” to save the parameter settings to the flash memory and the machine will
return to Normal Working Status. Note: if the Button “5” is not pressed the machine will not save
the parameters or return to Normal Working Status and the user may continue to change the
parameters.
e). If you need change the parameter next time, repeat operations from step “a)”to step “d)”.
4.3. Operations in Password Enabled Mode:
User can press the four buttons to change the parameters settings as described in above section
3. “Button Functions”.
4.4. Super Administrator Password:
If you forgot the password, please contact Avery Dennison.
4.5 Password Change: You may change the password by following the display
instructions.