Avery Dennison ALS 306, Installation Manual, Page: 49 / 56

49
2 I
NSTALLATION
2.3 C
ONNECTING THE SENSORS
ALS
306
309
Function test
Prerequisite:
– Machine is in dispensing mode.
–
MACHINE SETUP > OD sensor warn. = „Warning“ (set-
tings according to“Enabling” auf Seite 47).
If the light beam of the sensor [87C] meets the reflector,
the following warning appears after the next label has
been dispensed:
The message disappears immediately, if the light beam
stops falling on the reflector.
If the OD sensor is connected to the applicator inter-
face :
– No status message will be displayed on the opera-
tion panel in case of low material (only the „OD sen-
sor“ signal will be activated)
– If no sensor is connected, the output signal
„OD sensor“ remains activated
ONLINE
OD sensor warn.