Avery Dennison ALS 306, Installation Manual, Page: 30 / 56

30
2 I
NSTALLATION
2.2 U
NPACKING
,
ASSEMBLING AND CONNECTING THE MACHINE
ALS
306
309
Setting length of the short/long dispensing
edge holder
The length adjustment range depends on the
type of dispensing edge holder and on the
mounting angle. In some cases, it may be ad-
visable to shorten the holding rods at their top
ends.

Loosen 4 set screws [45A].

Shift the holder rods [46A] to the required height.

Tighten the set screws.
Setting length of the Euro dispensing edge
holder

Release clamp levers [47A] and [47B].

Roughly push the dispensing edge [47C] into the
favoured position (rough adjustment).

Tighten the upper clamp lever [47A].

Move the dispensing edge to its final position by
rotating the hand wheel [47D] (fine adjustment).
– One rotation of the hand wheel moves the dispen-
sing edge by 2 mm in the hight.

Tighten the lower clamp lever [47B].
[45] Short dispensing edge holder in 0°-position.
[46] Setting the length of the dispensing edge holder.
A
A
[47] Setting the length of the Euro dispensing edge holder.
A
B
C
D