42
normal status is high, set the sensor condition to low.
Click
IP Cam Sensor
to IP camera sensor reset condition. Click High or Low column
to set the reset condition of alarm.
7. In
(6) Action
,
you may now set the alarm action for the system to perform when the
alarm condition is activated.
-
Launch E-Map
Display mini Emap screen.
-
TV Out
Switch to only display the video on TV from where the alarm is activated.
-
Enlarge Camera View
Switch to only display video in Preview/Advanced mode from where the alarm is
activated.
-
Relay Output
Set to enable/disable the relay operation when the alarm is activated and to
extend additional time in second before it stops the relay operation (see also
).
-
IP Camera Relay
Set to enable/disable IP camera relay trigger. Click
ON
column to enable/disable
the relay trigger. The blank column means the trigger is off.
-
-
Play Warning Sound
Play alarm sound. To setup click
Detail
).
-
Make Phone Calls
Dial and contact the number in the list. To setup click
Detail
). To
use this feature, the PC must have a voice modem connected to it. The supported
audio system is only 8KHz and 16Bit mono.
-
Send E-mail
Send an electronic text message. To setup click
Detail
).
-
File Transmission via FTP
