Avaya X330W-2DS1, User Manual, Page: 144 / 176

Chapter 7 X330WAN CLI Commands
122 Avaya X330W-2DS1 User’s Guide
Note: If you cannot configure the hardware’s receive sensitivity, the receive
sensitivity is fixed at 36 dB and is unaffected if you enter
gain26
or
gain36
.
Example:
The following example changes the CLI receive sensitivity to match the actual
receive sensitivity of the hardware and adds 15 dB of attenuation to the transmit
signal:
X330WAN-2DS1-1(config-controller:1)# cablelength long
gain36 -15db
Example:
no cablelength
cablelength short (Controller Context)
Use the
cablelength short
command to configure transmit attenuation for a
cable length (line build-out) of 655 feet or shorter for a T1 trunk with a DSX-1
interface. Use the
no
form of this command to restore the default value.
Note: This command can only be performed if the controller is set to T1.
The syntax for this command is:
cablelength short {133ft|266ft|399ft|533ft|655ft}
short Configures parameters using the loop length.
133 Cable length of 0 to 133 feet. This is the default value.
266 Cable length of 134 to 266 feet.
399 Cable length of 267 to 399 feet.
533 Cable length of 400 to 533 feet.
655 Cable length of 534 to 655 feet.