Page 44 - IP401 Expansion and Installation of Integral Modules
Installing a New System
IP401 Expansion and Installation of Integral Modules
An IP401 Compact Office 2 can be expanded to an IP401 Compact Office 4. Either unit can be
expanded with a WAN card. In addition, either or both an optional Voice Compression Module (VCM)
and/or a VME module (providing memory capacity for embedded voice mail) can be fitted.
Procedure:
1. To add a VME memory card you do not need to de-assemble a module, simply:
- Insert the VME memory card (item
n
) into the slot in the rear panel below the
WAN port position (item
o
).
2. Remove the top cover (item
p
) from the base cover by removing the four retaining screws (two
either side - items
q
) and proceed as follows.
3. To expand an IP401 Compact Office 2 to an IP Compact Office 4:
- Remove and discard the front panel (item
r
).
- Remove the rear panel (item
s
). Only discard if a WAN module is being fitted (see below).
- On the rear panel, press out the molding for the additional BRI RJ45 socket (item
t
).
- Plug the expansion board (item
u
) onto it's sockets and stand-off hex. pillars.
Ensure that the additional BRI RJ45 socket slots into the hole in the rear panel (item
t
).
Secure the expansion board (item
u
) with the three retaining screws.
- Mount the new front and existing rear (if a WAN module is being fitted, see below) panels.
4. To add a WAN module:
- Remove and discard the rear panel (item
s
).
- Fit the new rear panel (with slot for WAN port 27-way D-type, items
s
and
o
).
- Mount WAN Module (item
v
) in position and secure with the two snap-in spacers.
5. To add a Voice Compression Module (VCM):
- Mount the VCM Module (item
w
) in position and secure with the two snap-in spacers.
Caution:
While installing modules, ensure that you wear aground wrist strap that is
connected to a suitable grounding point.
Page 44 - Installing a New System
IP Office Installation Manual
IP401 Expansion and Installation of Integral Modules
40DHB0002USCL – Issue 7 (09/25/2002)
