Avaya G150, Installation And Configuration Manual

Page: 40 / 254

Installing Hardware for the G150 Media Gateway
40 Installation and Configuration of the G150 Media Gateway
5. Install all telephones in their appropriate locations. For wall mounting, see G150 Shelf/Wall
Mounting below.
6. Connect your PC LAN Port to one of the LAN Ports on the front of an G150 using a LAN
Cable.
7. Switch on the ac mains supply.
8. The Manager software (provided on the Administrator CD) can now be installed on the PC.
For detailed instructions on installing Manager, see The Manager Application Software in
Chapter 3.
G150 Shelf/Wall Mounting
The G150 is not designed for rack mounting. All variants of the G150 can be either shelf or wall
mounted. Four retaining slots (item 1 below) enable the G150 control unit to be mounted and
secured either:
●
Horizontally on a shelf - leaving sufficient space for the cabling at both front and rear of the
unit.
●
Vertically from a wall - with the front panel facing down only.
Figure 6: Wall Mounting Sample
A Z-bracket (item 2 below, supplied with unit) is used to retain the G150 control unit in position.
!
CAUTION:
CAUTION:
The Z-bracket must not be used as the sole mounting fixture.
!
CAUTION:
CAUTION:
When mounting vertically, the weight of the control unit must be held by the two
No. 8 Panhead screws located into the retaining slots.
!
CAUTION:
CAUTION:
When mounted vertically, the air vents (on the rear panel of the G150) must be
on the top surface. e.g. item 2 below must be fitted above the unit.