Avaya G150, Installation And Configuration Manual

Page: 110 / 254

Configuring the G150 Media Gateway with Manager
110 Installation and Configuration of the G150 Media Gateway
●
DTMF:
- Mark: Default = 80 (80ms)
- Space: Default = 80 (80ms)
●
Intermediate Digit Pause: Default = 50 (500ms)
●
Voicemail Recording Level: Default = Low
Used to adjust the volume level of calls recorded by voicemail. Options are Low,
Medium and High.
●
Pulse On Width: Default = 40 (40ms)
●
Pulse Off Width: Default = 60 (60ms)
●
Await Dial Tone: Default = 15 (1.5second)
Sets how long the system should wait before sending the digits out toward the central
office. This may be necessary when older tone receiver equipment is employed in these
public network offices.
●
Gains:
- Tx (A-D): Default = 0dB
- Set the transmit gain between -4.0 to +3.5dB in 0.5dB steps.
- Rx (D-A): Default = 0dB
- Set the receive gain between -4.0 to +3.5dB in 0.5dB steps.
6. When all necessary settings are configured, click OK.
7. If this is the last configuration being performed on Manager, click Save. In the Sending
Config To dialog box, accept the selected save option and click OK. Otherwise, continue
making additional configuration updates and perform a Save when ready.
Quad BRI Trunk Configuration
Control of trunks in sub-tending mode is driven by Communication Manager, with the exception
of certain low level BRI trunk parameters, which are configurable via Manager. On this same
configuration, the Prefix and Group options apply to the G150 in survivable mode only.
To configure the Quad BRI Trunk:
1. Click to receive a configuration form. The Receiving Config from dialog box appears
displaying the IP address of the G150. Enter the G150 system password.
2. Click Line configuration from the Configuration Tree and double-click the BRI Trunk to be
configured.