Chapter 4 Registering, deregistering, and resetting the Avaya 7406E Digital Mobile Handset
45
Avaya 7406E Digital Mobile Handset Installation and Configuration Guide
12
Set the DIP switches to normal operation mode if you are finished registering handsets with
the base station. Otherwise, repeat steps 1 through 10 for remaining unregistered handsets.
The base station status LED flashes normally once you set the base station back to normal
operation mode.
13
Plug the power source back into the base station.
14
Power cycle the base station.
Deregistering one handset
Make sure the base station is in idle mode, the handset is in standby mode, and that you have
removed power to the base station before you start this procedure.
Registered handsets lose their registration with a base station even when the power connector is
disconnected from the base station.
Refer to
Appendix A, “DIP switch settings
” for the correct DIP switch settings.
1
Log on to the
Maintenance
menu.
2
Use the up and down softkeys to navigate to the
De-Registration
option.
3
Press
Select
.
4
Use the up and down softkeys to navigate to the
Yes
option.
5
Enter the port ID that is assigned to the handset.
6
Press
Select
.
7
Press
OK
.
The set is now registered.
Deregistering all the handsets
Make sure the base station is in idle mode, the handsets are in standby mode, and that you have
removed power to the base station before you start this procedure.
Registered handsets lose their registration with a base station even when the power connector is
disconnected from the base station.
Refer to
Appendix A, “DIP switch settings
” for the correct DIP switch settings.
1
Remove the power source from the base station.
2
Set the DIP switches to deregistration mode.
3
Plug the power source back into the base station.
4
After several seconds, the base station enters deregistration mode.
All handsets are deregistered from the base station. Handsets cannot link to the base station.
5
Place all handsets near the base station.
All deregistered handsets return to nonregistered mode. The
Please Register!
message
appears on the LCD.
Summary of Contents for 7406E
