Avaya 7406E, Installation And Configuration Manual

Page: 40 / 60

40 Chapter 3 Installing the base telephone equipment
NN40110-301 NN40110-301
Securing the base station mounting bracket
Complete this procedure if you plan to mount the base station on a wall or ceiling. Skip this
procedure if you plan to place the base station on a flat surface.
1 Place the mounting bracket against the wall or ceiling where you want to install the base
station.
2 Use the mounting bracket as a template to position the base station and to mark the screw
positions.
3 Use the four screws to attach the mounting bracket to a wall or ceiling.
Connecting the telephone line and power adapter to the base
station
1 For a single handset installation, plug one end of the line cord into the telephone jack on the
base station labeled TCM1. For a multiple-handset installation plug the line cord into the jack
labeled TCM1-4.
If you are connecting more than one handset to the base station, you cannot connect any
handset to the TCM1 jack. You must connect all TCM lines to the TCM1-4 jack.
2 Connect the other end of the line cord into a telephone port on the system equipment.
For wiring information, refer to Appendix B, “Wiring information,” on page 55 .
3 Plug the small end of the power adapter into the back of the base station.
4 Plug the other end of the power adapter into an AC outlet near the location of the base station.
Mounting the base station
Complete this procedure if you plan to mount the base station on a wall or ceiling. Skip this
procedure if you plan to place the base station on a flat surface.
1 Align the notches on the back of the base station with the mounting bracket on the wall or
ceiling.
2 Push the base station against the brackets until they are securely connected.
3 Adjust the antennas on the base station for optimal signal reception.
For the best radio reception, make sure the antenna on the base station are always vertical.
Installing the external battery charger
1
Plug the small end of the power adapter into the back of the battery charger.
2 Plug the other end of the power adapter into an AC outlet near the location of the charger.
3 Place one or two battery packs in the charger.
The red LED for each battery pack slot flashes to indicate that the battery is charging. The
Avaya logo lights. The LEDs turn green when the battery packs are fully charged.