Avaya 7406E, Installation And Configuration Manual

Page: 38 / 60

38 Chapter 3 Installing the base telephone equipment
NN40110-301 NN40110-301
Tools and materials
Before you install the base station, ensure that you have the following tools and materials:
• tools
— Phillips or flat-head screwdriver, depending on the type of screws you have
— 2 screws
— pen or pencil
• package contents
— Avaya 7406E Digital Mobile Handset
— Avaya 7406E Digital Mobile Handset charging cradle and ac power cord
— Avaya 7406E Digital Mobile Handset base station and ac power cord
— 1 telephone cable to connect the base station to the telephone jack
— belt clip
• additional material
— additional customer-supplied cables for RJ45 connector if you are installing more than
one handset
Installing the handset charging cradle
1 Plug the small end of the power adapter into the back of the charging cradle.
2 Plug the other end of the power adapter into an AC outlet near the location of the cradle.
3 Place the handset in the cradle to charge the battery.
Installing the battery pack
Complete this procedure if the battery pack is not already installed in your handset.
1
Use your thumb to slide the battery compartment cover down and off the back of the handset.
2 Position the battery pack in the bottom position inside the battery compartment.
3 Firmly press the top of the battery pack into place.
Warning: You must complete the steps in this section when you first initialize a
base station and configure the first handset.