Chapter 1 About Avaya 7406 Digital Mobile Handset
11
Avaya 7406 Digital Mobile Handset — Installation Guide
•
Ensure that the telephone lines from your system have been installed to the base station
location.
Mounting and Connecting the Base Station
Follow these steps to mount and connect each base station.
1
Use the mounting bracket as a template to position the base station and mark the screw
positions.
2
Use screws to attach the mounting bracket to a wall or ceiling.
3
Set the base station dip switches, located on the back of the base station, to the required ISM
frequency band.
4
Connect the telephone lines to the base station.
5
Align the notches on the back of the base station with the mounting bracket on the wall.
6
Push the base station against the brackets until they are securely connected.
•
On the first base station you install, set
the dip switches to operate in the upper
half of the ISM band. From left to right, set
to
Down-Up-Down.
•
On the second base station, set the dip
switches to operate in the lower half of the
ISM band. From left to right, set to
Down-Down-Up
.
a
Plug one end of the line
cord into a telephone jack
on the base station.
b
Connect the other end
into a telephone port on
the system equipment.
c
Connect a maximum of
three TCMs per base
station to the system.
d
Plug the small end of the
power adapter into the
back of the base station.
e
Plug the other end into an
AC outlet.
Note:
A red light flashes continuously
on the base station when powered.
Upper half
ISM Band
1 2 3
Lower half
ISM Band
