4. Certifying the Installation
3600 Series IP Phone Installation
Page 55
IP Office 4.0
15-601082 Issue 05a (22nd May 2007)
•
Confirm Supported Data Rates
Press
FCN
to display
Det1
on the base of the display. The phone is now showing full
details for an individual access point. Use this to confirm signal strength and supported
data rates. Use the right arrow key to display the second best access point, arrow again
to the third best, and so on to the fourth best. The left arrow key steps you back to the first
best.
#: Full MAC
dB Ch 1b2b5b11b
Detl
•
#:
the number (1-4) of the access point.
•
Full MAC:
the MAC address of the access point.
•
dB:
the signal strength of the access point.
•
Ch:
the channel of the access point.
•
1b2b5b11b
is an example of the data rates that may be displayed.
Each data rate (1,2,5.5, or 11Mbit/sec) that is supported by the access point is
shown. Those rates that are in the Basic Rate set (sometimes referred to as
“required” rates) are indicated by a ‘b’ following the rate number. The Supported
and Basic data rate(s) should be the same on all access points as is appropriate
for your environment.
9. When testing is complete, to power off the wireless phone press
Power Off/End Call
.
