3600 Series IP Phone Installation
Page 37
IP Office 4.0
15-601082 Issue 05a (22nd May 2007)
3. Phone Configuration
3.1 Installation Requirements
This section covers registration of the 3600 Series phones following setup and configuration of the
wireless network, AVPP, TFTP server and if necessary DHCP server.
Pre-Installation Requirement
s
1.
Battery Charge
Ensure that the battery pack on the wireless phone is fully charged.
2.
TFTP Server
The TFTP server has been setup and tested.
3.
Phone Software
The required 3600 series phone software has been placed onto the TFTP server.
4.
AVPP
The AVPP has been configured.
5.
Wireless Network
The wireless access points are operational and that a thorough site survey has been conducted.
6.
DHCP Server
(if being used)
The DHCP server, if being used, is running and has the necessary scopes configured to provide
the same information as listed for static IP address configuration listed below.
Tools Required
1.
PC with IP Office Manager
Information Required
1.
TFTP Server IP Address
2.
AVPP IP Address
3.
Wireless Network
The wireless access points are operational and that a thorough site survey has been conducted.
Ensure that you have the following information about the wireless network:
1.
SSID
2.
Frequency. For example 802.11a or 802.11b.
3.
Security information. For example WEP key and key length if that is the security
method being used by the wireless network.
4.
Static IP Address Information
If not using a DHCP server, ensure that you have the following network information:
1.
IP Address for each phone.
2.
Sub-net mask
3.
Default gateway.
4.
Call Server IP (IP Office)
5.
Call Server Port (1719).
5.
Phone User Details
For each phone, ensure you have the following information:
1.
Required extension number.
