AS-1585 SH
Installation Guide
P. 17
The Parking Light output from the Remote Car Starter will activate when the
vehicle starts and shut off once a Tach signal is detected.
4. Press the
Brake Pedal
and keep it down until you hear the Parking Lights Output
flash 5 times.
5. Shut down the Engine. Tach Programming is now complete.
Table 6: Automatic Tach Programming
Horn Honk Timing
Follow these steps to program Horn Confirmation:
1.
Ensure that the Hood is up and that the Ignition is
OFF
.
x
Hold the Hood Pin-switch down for 4 seconds.
x
Release the Pin-switch. The Parking Lights will come on.
x
While the Parking Lights are on, immediately push and release the
Pin-switch
again.
The Parking Lights will stay on for up to 20 seconds
.
2.
Press and hold the Brake Pedal, then simultaneously press the
UNLOCK
and
START
buttons on the Transmitter –
the Horn will honk 5 times
.
3.
Release the Brake Pedal.
4.
To change the timing:
a. To increase the Horn pulse by 3 ms, press the
LOCK
button.
b. To decrease the pulse by 3 ms, press the
UNLOCK
button.
c. To increase the pulse by 10 ms, press the
START
or
STOP
button.
d. To decrease the pulse by 10 ms, press the
TRUNK
button.
5.
To save the new settings: press
LOCK
and
UNLOCK
. If 3 honks are returned the new
settings have been saved.
Table 9: Adjusting Honk Duration
Otherwise close the Hood to cancel the changes.
For each timing change, the Horn will honk with the new settings, except in the
following cases:
x
When the lower limit of 5 ms is reached, there will be a 1/4-sec. honk.
x
When the upper limit of 200 ms is reached, there will be a 3/4-sec. honk.
A system reset will set the Remote Car Starter back to the default values: 30 ms.
Testing
Before putting back the vehicle together, it is recommended to check that the system
operates properly. The following testing procedures should be used to verify proper
installation and operation of the system. Before testing, make sure that all connections are
soldered and that the unit is plugged in.
Make sure the Remote Car Starter properly
enters and exits Ready Mode
:
Setting the system to Ready Mode
1. Ensure that all the Doors are closed and that the Gear Shift Lever is in the
NEUTRAL
position.
2. With the Engine already running, apply the Parking Brake and release the Brake
Pedal.
Make sure to release the Brake Pedal.
3. Within 20 sec. push
LOCK
,
UNLOCK
or
START
on the Transmitter.
The Parking Lights will flash 3 times quickly and remain lit.
