AS-1585 SH
Installation Guide
P. 25
Diagnostics – Parking Light Flash Table
Flashes
Description
1
x
Doors locked, Starter Kill armed.
x
End of Run Time.
x
TRUNK
button pressed
x
Start signal received by the Remote Car Starter.
x
Cold Weather Mode cancelled.
x
Cannot start after maximum number of attempts is reached.
2
x
Doors unlocked, Starter Kill disarmed.
x
Remote start attempt cancelled by remote.
3
x
Entering
Cold Weather Mode
.
x
Entering or Exiting
Ready Mode
.
x
Entering Extended Run Time.
4
x
+12 V where detected on the brake line and cranking was cancelled.
x
Entering Tach-programming Mode
5
x
New Transmitter programmed.
x
Tach programmed.
6
x
A remote start was attempted while a Tach or a vacuum signal was detected
before cranking.
8
x
Unit reset: occurs when the Unit is reset to the factory defaults.
10
x
The Hood Switch line went to ground during cranking or Run Time.
1 – pause – 2
x
There was an attempt to start the vehicle while the Remote Car Starter was
in Valet Mode.
2 – pause – 2
x
There was an attempt to start the vehicle while the Remote Car Starter was
in Home Valet Mode.
4 – pause – 3
x
The vehicle went out of Ready Mode: +12 V detected on the Brake Line.
10 – pause – 3
x
The vehicle went out of Ready Mode: the Hood Pin-switch went to ground.
ON 2 sec.
x
The Hood is up and the Hood Switch line went to ground. This is step one of
the Programming Centre procedure.
ON 3 sec.
x
First press of the
START
button under Safe Start.
ON 4 sec.
x
Locking or unlocking a Door (with Door pulses configured to 4 sec.)
ON 25 sec.
x
The Hood Pin-switch has been pressed twice: the Unit went into step 1 of the
Programming Centre procedure, and no Transmitter activity was detected for
20 seconds.
x
Or
the Unit went into step 1 of the Transmitter Programming procedure and
no activity was detected for a few seconds. The Unit has exited the
Transmitter Programming procedure.
Irregular
x
If the unit gives irregular signals (1 to 10 flashes followed by a pause,
followed by further flashes), the system is playing back Start Failure Codes.
This occurs when the Hood Pin-switch is pressed three times
.
Constant
flashes
up to 30 sec.
x
Panic Mode was triggered.
