17
‘Change Password’
This enables the owner to enter a password of personal choice.
Any personal password must be made available to Autobox engineers when
needed.
‘Select Motor’
This enables the drive system to be configured to operate with an alternate
motor.
On no account should this be changed without consulting Autobox.
Please Note: The calibration set-up, as detailed above, is intended to allow the machine to be ‘fine
tuned’ to produce consistent, accurate boxes. If the boxes are inconsistent, i.e. the panel sizes are
varying, then the problem will not be solved by re-calibrating. Inconsistencies are caused by
mechanical slippage of the encoder wheel or the drive mechanism, or by the blanks jamming in the
machine.
ERROR MESSAGES
‘Current Drive Error’
This indicates an error in the drive system and is normally seen when the
blade drive motor has not been switched on.
If a ‘lag error’ message is also shown while making a box, this indicates that
the box has not moved through the machine as calculated by the computer.
This may be because the crease wheels are set too light to grip the board, the side guides may be too
tight or there may be a stack of blanks on the Auto-Feeder too heavy to allow the boxes to move
through the machine.
If a box is jammed in the machine and the error message appears, as above, touch the
‘Acknowledge’ button and the ‘Manual Control’ screen will appear. This allows the operator to
drive the box out of the machine, forward or backward, and then touch the ‘Back’ arrow to return to
the ‘Run’ screen and continue.
