PLACA DIRECTORIO
– DIGITAL PANEL DIRECTORY
15
Funcionamiento
-
Functioning
F L O O R 1
F L A T s ? :
█
F L O O R 2
F L A T s ? :
█
F L O O R 3
F L A T s ? :
█
S D L 2
F L O O R s ? :
█
F L O O R 1
F L A T s ? :
█
F L O O R 2
F L A T s ? :
█
O
K
█
•
We can exit the ‘Auto’ mode at any time pressing the
C
key, nevertheless, it is a good practice to
review the Directory, in order to verify the registers added in the data base; and delete them if they
are not needed. (Each time a ‘flat number’ is accepted, the system fills the data base with that
amount of registers)
9
.
•
To erase the registers, choose the option ‘Erase: 2’ from the Directory Menu as shown bellow.
D e l e t e A L L ?
y e s
, n o C
E R A S I N G > > 0
P e d r o
1 º A - - - - 0 0 0 2 2 2
9
If the number of flats is high, the system will expend a few
seconds in the generation of the corresponding registers.
Press
.
Number of Flats in the first
floor of the SDL1. Press ‘4’+
.
Press 4+
.
Number of Flats in
the second Floor of the SDL1.
Press ‘3’+
.
Press 3+
.
Nº of Flats in the
third Floor of the SDL1. Press
‘4’+
again.
Press 4+
.
Now that SDL1 is
finished, the system asks for the
nº of Floors in SDL2. Press ‘2’+
Press 2+
.
The first Floor of
SDL2 has 3 Flats. ‘3’+
should be
entered.
Press 3+
.
The second floor of
SDL2 only has two flats. ‘2’+
should be pressed.
Press 2+
.
The automatic
installation has finished. The system
shows the message ‘OK’ and waits for
any key pressed.
Erase: 2
Press C instead of
.
We can navigate
through the data base using (
Å
,
Æ
) and
press
OK
when we find the register we
want to erase.
Press
.
The system shows a
progress bar and indicates that it is
erasing the partition 0.
From the Directory Menu Press 2.
Delete all the data base pressing
.
