© 2009 Austin Kontore LLC
Page 11 of 54
Follow this same process to align and mark the left and
right sides of the panel.
Goal
: Have an equal amount of overlap on the left and
right sides.
Using the marks made above, center the 5 mm plywood
panel within the frame.
Important:
Make sure that the darker; more
attractive, side of the plywood is facing down. This is the
side that will be facing outwards.
The 5 mm plywood panel should have an even alignment
on the top, bottom, left, and right.
Drill pilot holes in top center and bottom center of 5mm
panel. Holes should be about ¾" from edge of the 5 mm
plywood.
Important:
Don’t drill too deep! You don’t want to
drill through the entire thickness of the wood. A hole
about ½” in depth is sufficient.
Use (2) ¾" Lathe screws to attach the plywood panel to
the frame.
Drill holes about 4” from each corner (total of 8 holes, 2
for each corner) about ¾” from edge of the plywood.
