© 2009 Austin Kontore LLC
Page 46 of 54
Repeat
the above steps for the remaining 3 – “L”
brackets.
Once complete, four “L” brackets will be attached to the
upper Core Square. All brackets will be flush to the top of
the Square.
Place the Roof Unit on the top of the coop. It should lie flat
one top of the upper Core Square.
Important:
Position the roof so that the troughs of the
roof are parallel to the doors. In other words, water runoff
should go toward the solid sides of the unit, not onto the
door rails.
Align the frame of the Roof Unit with the Core Square.
Goal:
The Roof Unit should be perfectly centered on
the Core. Take some time to make sure that everything is
lined up properly.
From inside the coop, fasten the first “L” bracket to the
Roof Unit frame with two ½” Lathe screws.
Note:
Fastening the screws will be easier if you hold
down the Roof Unit frame with your fingers while driving
the screws.
Repeat
the above steps for the remaining (3) “L”
brackets. The roof is secured when all four “L” brackets are
fastened to the Roof Unit frame.
