Aurora Archer IS720G, Installation & Operating Instructions Manual, Page: 7 / 51

INSTALLATION INSTRUCTIONS
GENERAL SAFETY INFORMATION
1. This installation must conform with local codes or, in the absence of local codes, with AS 5601.
2. Provide adequate clearances around the product for servicing and ensure there are no obstructions to the combustion
air intake situated at the back of the heater. (Refer Page 5 item 10 and page 7)
3. The appliance must be installed on a flat level, solid continuous surface (i.e. wood, metal, concrete). Please Note:
Rough or uneven surfaces can cause vibration or humming in the heater.
4. The Archer Gas Space Heater can be installed in a wide variety of ways and will fit nearly any room layout. It may
be installed in a recessed position, framed out into the room, or across a corner. For installation options refer pages 11
through to 16.
5. This appliance (Insert and Freestanding Models) needs to be installed in such a way that the heater can be removed at
all times to service the heat exchanger and flue fan located in the rear section of the heater.
NOTE: UNDER NO CIRCUMSTANCES SHOULD THE APPLIANCE BE INSTALLED UNDER
CONDITIONS, WHICH WOULD NOT ALLOW FOR EASY REMOVAL OF THE APPLIANCE TO
CARRY OUT ROUTINE INSPECTION AND SERVICE TO APPLIANCE. TO DO SO WILL VOID
THE WARRANTY.
Note: On Single Wall Flue Pipe installations (imitation zero clearance fireplace) a minimum of 25mm clearance must be
provided at the rear of the heater to enable the heater to get sufficient combustion air to the air inlet located at the rear of
heater. (Refer page 5 item10)
6
FAILURE TO INSTALL THIS APPLIANCE CORRECTLY MAY
CAUSE A SERIOUS HOUSE FIRE.
!
THIS APPLIANCE SHOULD BE INSTALLED BY A QUALIFIED
LICENSED GAS FITTER.
!
DUE TO HIGH TEMPERATURES, THE APPLIANCE SHOULD
BE LOCATED OUT OF TRAFFIC AND AWAY FROM
FURNITURE AND DRAPERIES.
!
IN CASES WHERE THE INSTALLATION OF THE HEATER IS
NOT IN ACCORDANCE WITH THE MANUFACTURERS
INSTRUCTIONS AND THE APPLIANCE CAN NOT BE
REMOVED FOR SERVICING WHERE SERVICE PERSONAL
HAVE TO SPEND TIME TO REMOVE THE HEATER OR
CORRECT THE INSTALLATION A SERVICE CHARGE WILL
BE APPLICABLE TO THE CUSTOMER OF LABOUR AT $80
PER HOUR PLUS GST PLUS TRAVELING EXPENSES.
!
THIS APPLIANCE CAN ONLY BE FLUED IN ACCORDANCE
WITH THE MANUFACTURER’S INSTRUCTIONS AS TESTED
TO AGA CODE 5601.
!