Aurora Archer IS720G, Installation & Operating Instructions Manual, Page: 41 / 51

40
FAULT
DESCRIPTION
LCD Digits Description ACTION
Anomaly as parasitic
flame, APT failure
or APS failure Desired
flame level
is shown

Yellow LED permanently OFF

Green and LED blink slowly and simultaneously
Turn off main power to the fireplace for 30 minutes.
Ignition Lockout “A1”

Yellow LED permanently OFF

Red LED permanently ON

Green LED performs 1 blink followed by a 1s
pause
Check for gas presence. Reset and retry ignition
sequence. If problem persists, contact a qualified
service person
High water level
fault
“A2”

Yellow LED permanently OFF

Red LED permanently ON

Green LED performs 2 blinks followed by a 1s
pause
Contact a qualified service person
Transducer fault “A3”

Yellow LED permanently OFF

Red LED permanently ON

Green LED performs 3 blinks followed by a 1s
pause
Check air pressure switch and air pressure
transducer hose connections. Reset fireplace and try
ignition. If problem persists, contact a qualified
service person
Pressure switch fault “A4”

Yellow LED permanently OFF

Red LED permanently ON

Green LED performs 4 blinks followed by a 1s
pause
Check air pressure switch and air pressure
transducer hose connections. Reset fireplace and try
ignition. If problem persists, contact a qualified
service person
Overheat lock-out “A5”

Yellow LED permanently OFF

Red LED permanently ON

Green LED performs 5 blinks followed by a 1s
pause
Allow fireplace to cool completely then reset
fireplace. If problem persists, contact a qualified
service person
Thermistor fault “A6”

Yellow LED permanently OFF

Red LED permanently ON

Green LED performs 6 blinks followed by a 1s
pause
Contact a qualified service person
Inadequate Combus-
tion Airflow “A7”

Yellow LED permanently OFF

Red LED permanently ON

Green LED performs 7 blinks followed by a 3s
pause
Contact a qualified service person
Thermistor temp too
high “A0”

Yellow LED permanently OFF

Red LED permanently ON

Green LED performs 1 blink followed by a 3s
pause
Allow fireplace to cool completely then reset
fireplace. If problem persists, contact a qualified
service person
TROUBLESHOOTING LCD FAULT CODES ON THE DISPLAY PANEL
Operation LCG DIGITS CONTROL BOARD LED SEQUENCE
Power on
sequence Blank

Yellow LED permanently OFF

Green and Red LED blink four times alternatively
Standby “—”

Yellow LED permanently OFF

Red LED permanently OFF

Green LED blink slowly and continuously
Operation Safety
Check Desired flame level is shown

Yellow LED on at pressure threshold check

Green and red LED’s blink rapidly and alternately
Heat Request Desired flame level is shown

Yellow LED permanently OFF

Red LED permanently OFF

Green LED blinking fast and continuously
TROUBLESHOOTING LCD CODES—NORMAL OPERATION