9
8
lead
terminals
3.
NO
COM
NC
lead
terminals
NC
COM
NO
It is a typical single-pole two-state relay. In most cases,
the NC terminal is not used
.
NOTE
:
After connecting the leads replace the plastic cover
.
cover
Fastening the controller on the wall
The battery compartment is located inside the controller, in the
front part of the enclosure. To place the batteries remove the front
panel as shown in the section
”Connecting the leads
to AURATON
3013"
.
battery
compartment
2x AAA 1,5 V
Put two AAA 1.5V batteries into
t h e c o m p a r t m e n t , o b s e r v i n g
the polarity.
To fasten the AURATON 3013 controller to the wall
:
1.
Remove the controller front panel
(as shown in the section
”Connecting the leads to 3013").
2.
Drill two 6mm dia holes in the
wall
(set the holes spacing
using the controller rear panel)
.
Placing the front panel: NOTE
NO
COM
NC
opening for the screw
