If for any reason you want to have the temperature
in the room reduced every day at the same time, then
you can reduce it temporarily by maximum 5°C. To
reduce the temperature
:
1.
it for 3 seconds.
(e.g. ).
T h e t e m p e ra t u re d i s p l ay
segment will go into the edit
mode and will start flashing
.
2
.
Turn the knob clockwise or
anticlockwise to reduce the
temperature by 1°C through 5°C.
Confirm your choice by pressing
the
button.
Press the button
and hold
below
m
OK
The display will show the moon
and
the hour counter
2.
Turn the knob clockwise or anticlockwise to set desired
temperature in the room with the 0.2°C accuracy
.
3.
.
The controller will revert to the normal operation mode
.
Confirm your choice by pressing the button
13
12
Setting the temporary temperature
reduction mode
3
.
The hour field on the display
will go into the edit mode and will start
flashing. Use the knob again to set the number of hours during
which the reduced temperature will be on. You can set from 1 to 12
hours
.
Confirm your choice by pressing
.
4.
The controller will activate the temporary temperature reduction
mode every day at the same time for the set number of hours
.
OK
NOTE
:
After the set time hours the controller will revert to the basic
temperature setting. On the display the moon symbol
will
be replaced by the sun
.
NOTE
:
The temporary temperature reduction mode always starts
when the function is activated. This means that the possible
temporary temperature reduction should be programmed
at the time when you want the temperature change
to happen
.
Switching off the temporary temperature reduction
mode
The controller will run the programmed temporary temperature
reduction every day at the same time until you switch off that
function.
To switch off, press and hold this button
for 3 seconds
.
