11
10
3.
Place the expansion plugs into the drilled holes
(plugs are
included in the kit)
.
4.
Fasten the rear panel to the wall using the screws included
in the kit.
5.
Replace the front panel
.
NOTE
:
In case of wooden wall you don't have to use expansion plugs. Just drill
the 2.7 mm dia holes (instead of 6 mm) in screw the bolts directly into
the wood
FRONT
PANEL
REAR
PANEL
Placing the front panel: NOTE
When replacing the front panel onto the rear panel pay attention to
the pin connection which transmits the control signals.
Pins
Pin socket
When replacing the front cover make sure that the pins are
inserted into the pin socket.
First start of the controller
After a correct placement of batteries
in the compartment all segments will
appear on the display for a second
(display test), followed by the software
version number (e.g. F02).
The current temperature in the room
will be displayed after a moment. The
controller is ready for operation.
Setting the temperature
NOTE
:
the first pressing of any function button always turns the display
backlight on, only the second pressing activates a given function
.
To set the required temperature in the normal operation mode
:
1.
Press the button.
The temperature display segment
will go into the edit mode and will
start flashing
.
