Aura Cebilon, User Manual, Page: 13 / 24

Waste
Water
Connection
Pre-tests
Figure 8. Mains inlet valve Figure 7. Waste water connection
• The appliance is designed for
domestic use. Parts such as
storage tank, waste water hose,
faucet must be attached indoor
environment. Necessary measures
should be taken to prevent freezing
and waste water flow.
• Use the appliance after the
necessary measures are taken in
microbiologically unsafe or
disinfected waters.
• The appliance must be supplied
with its own power adapter.
• If the appliance will not be used
for a long time (such as more than
1 month), the inlet water valve must
be closed (figure 9), the tank should
be drained and the adapter should
be plugged out and the authorizes
service must be called to disinfect
the appliance when reactivating.
• When there not anyone in the
house, close the water inlet valve of
the appliance for safety purposes
(Figure 8).
• The appliance must not be
interfered for repair and
maintenance purposes. Otherwise,
it falls out of the warranty scope,
these operations are carried out by
Ihlas Authorized Service.
• As the inlet water temperature
changes, the amount of clean water
to be received and the efficiency
may change. Therefore, water
obtained may be low in winter and
high in summer.
• In any unfavorableness (Figure 8)
close the water inlet valve and
consult Ihlas Authorized Service.
** Included in the 101 ME and 101 MD models only.
• If waste water pipe of the sink is
not a throat hose but a 40 mm
plastic pipe, it is mounted in a 3/8"
clamp sealing sponge affixed state
(Figure 7a).
• The flush is drilled from the hole
of the clamp in 8 mm diameter on
the same axis (Figure 7b). One
end of the 3/8" waste water faucet
is connected to this clamp and the
other end is connected to the 3/8"
waste water union.
• If waste water hose will be
mounted on the 50 waste water
installation, a 3/8" clamp will be
mounted and the waste water
hose will be mounted on its
location above this. A seal must be
used when mounting the adapter
to the waste water installation.
Points
for
Attention
a
b
• The adapter is plugged in after it
is placed into the place where "24
V DC" is written on the appliance.
In this case, it will not work due to
lack of water and pressure in the
system.**
• Clean water faucet is turned on.
• Mains water is supplied to the
system by opening the 1/4 ball
valve (Figure 8). It is seen that
the pump is running.**
• The faucet is closed after a
small amount of water flows from
the clean water faucet.**
• After the operation of the pump
stops, leak test of all the
connections in the system is
performed, the tank valve opens.
• This system should be used
after the twenty-four hours
washing process,
(Installation is done after this
process is carried out by an
authorized service.)
• Tank valve must be closed.
• After the washing process since
the tank will be filled with water
for the first time. Tank water is let
to flow for no purpose. Now the
appliance is ready to use.
13