Installation
Filter Flushing and Conditioning Procedures
Your appliance is very practical for use and the
water installation can be easily installed anywhere.
Installation of your appliance must be
made by Ihlas Authorized Services.
• Aura Cebilon Reverse Osmosis System contains
critical components that are required to be
replaced periodically to purify the total dissolved
solid materials (TDS). To check the efficiency of the s
ystem, water from the appliance must be
periodically tested.
•
Free chlorine may affect the polymer structure of the
membrane filter that is located inside the system.
• Please read the instruction manual for installation,
operation, maintenance and warranty terms.
Installation diagram for the appliance is shown in
Figure 4.
The first three filters shall be flushed separately.
Firstly close the ball valve that supplies mains water
to the system. Remove the outlet tube on the
housing cover of first filter. Insert one meter ¼ Inch
tube to the outlet of the cover. And then open the
ball valve, flush the filter for 2-3 minutes with mains
water. Insert the outlet tube to its place and follow
the same procedure for the other two filters.
After that when you flush membrane filter remove
tubes on the both outlets of the membrane
housing. Insert one meter tube to the both outlet.
Flush the membrane for 2-3 minutes to clear
membrane form protective membrane solution.
Install the tube that has flow restrictor on it but not
to install the tube that goes to post carbon filter.
Allow water flow for 2-3 minutes to clear the
membrane solution completely. And then install the
tube that goes to post carbon filter.
Then storage tank will be filled for the first time,
tank water is let to flow for no purpose, for at least
once. The appliance is now ready to use.
When you flush filters, some water drops can cause
E2 (water leakage error). So dry the sensor and the
device completely. Be careful that there will be no
water drop in the device somewhere. If you
experience such a problem, dry the sensor and
device and then pull out the plug and then install
the plug again the E2 error will disappear.
Also there are three pcs L elbow that is not installed
to the device. These elbows should be fixed to the
inlet and outlets of the device for preventing tube
breakage.
Please make sure that, flushing the filters, before you start using the device. For filters
flushing, you can follow the instructions below.
Warning
1- Measures should be taken against freezing.
2- Waste water should not interfered with.
3- When muddy (clay) water comes from the mains,
close the water inlet of theappliance.
4- If a water supply other than the mains will be
used, you must receive a drinking water report
from relevant institutions.
5- If it is a water source other than the mains water,
make sure that the disinfection process is
performed.
6- Filters are considered as supplies and are outside
the scope of warranty.
10
Summary of Contents for Cebilon
Page 19: ...19...