12
Water Connection
• Close the mains water from the apartment inlet valve.
• After draining the water left in the pipes from proper places, mount the three-way
adapter to the mains by ensuring the sealing.
•
First, mount the 1/4 ball valve to the three-way adapter by wrapping a teflon tape in a
position so that the valve is opened and closed easily (Figure 5.a).
• Connect the water inlet hose to the ball valve (Figure 5.b).
• Make sure the ball valve is closed (Figure 5.c).
• Open the mains water, check whether there is any leakage (Figure 5.d).
• Place the appliance on a suitable place underneath the counter in upright position.
Figure 5. Water connection fittings
Installing the faucet
Clean water faucet should be mounted carefully in terms of use and aesthetics. If the counter or kitchen sink will be
drilled, drilling process should be proceeded after the dimensions are obtained so as to install the washers, nuts and
unions under the counter or kitchen sink (Figure 6). Otherwise, drillingmay be incorrect.
The location to be drilled may be granite, marble, concrete or stainless sink. If the counter is granite, it must be drilled
with a 20 mm diameter bore bit. Bore bit is attached to the end of the drill and it is set to low speed. Water is poured
on the ground to be drilled (do not drill without water). Bend the bore bit as 45 degrees and press slightly, it makes
a trail on the granite. Then it is brought to an upright position slowly without lifting. When it reaches the upright position,
drilling iscompleted by applying enough force. If the bore bit is not kept constant when we start drilling, parts can break
off from the granite surface. The o-ring on the faucet's mirror cannot ensure sealing and may cause the water leakage
down from the counter. Marble countertops can be drilled by the same drilling bit or bore bit. Concrete countertops
are drilled with a contact tip and hammer drill. If concrete is coated with tiles, a pre drill is made with a small-diameter
drill bit to avoid cracking the tiles. Bore bit for the stainless sinks is different.
The hose should be mounted carefully between the faucet mounted
on the counter and on the appliance where "Clean Water" is written.
Figure 6. Faucet
13 Faucet Screw
14 1/4” Hose
12 Compression Nut
11 Crinkled Spring Washer
9 Mounting Plastic
10 Plastic Mounting Washer
7 Body Bushing O-ring
8 Mounting Parts
6 Body Bushing
5 Faucet Body
4 Hub Cover
3 Opening/Closing Handle
2 Upper Body Part
1 Faucet Pipe
b
d
c
a
Summary of Contents for Cebilon
Page 19: ...19...