9.4.
Output speed (internal): set
9.5.
Fieldbus address (slave address), baud rate, parity and monitoring time: set
9.6.
Test run
9.6.1.
Direction of rotation at mechanical position indicator: check
9.6.2.
Direction of rotation at hollow shaft/stem: check
9.6.3.
Limit switching: check
10.
Commissioning (settings/options in the actuator).............................................................
10.1.
Switch compartment: open/close
10.2.
Mechanical position indicator (self-adjusting)
10.2.1.
Mechanical position indicator: set
10.2.2.
Gear stage of the reduction gearing: test/set
10.3.
Mechanical position indication via indicator mark (not self-adjusting)
10.3.1.
Mechanical position indicator: set
10.3.2.
Gear stage of the reduction gearing: test/set
11.
Corrective action....................................................................................................................
11.1.
Faults during operation/commissioning
11.2.
Fault indications and warning indications
11.2.1.
Signal "Motor protection tripped” (via TMS device)
11.3.
Fuses
11.3.1.
Fuses within the actuator controls
11.3.2.
Motor protection (thermal monitoring)
12.
Servicing and maintenance...................................................................................................
12.1.
Preventive measures for servicing and safe operation
12.2.
Disconnection from the mains
12.2.1.
Disconnection from the mains with KP/KPH and KES electrical connection
12.2.2.
Disconnection from the mains with KT/KM electrical connection
12.3.
Maintenance
12.4.
Disposal and recycling
13.
Technical data.........................................................................................................................
13.1.
Technical data Multi-turn actuators
13.2.
Technical data Actuator controls
14.
Spare parts.............................................................................................................................
14.1.
Multi-turn actuators SAVEx 07.2 – SAVEx 16.2/SARVEx 07.2 – SARVEx 16.2
14.2.
ACVExC 01.2 KP/KPH actuator controls
14.3.
ACVExC 01.2 KES actuator controls
14.4.
ACVExC 01.2 KT/KM actuator controls
15.
Certificates..............................................................................................................................
15.1.
Declaration of Incorporation and EU Declaration of Conformity
Index........................................................................................................................................
Addresses...............................................................................................................................
4
SAVEx 07.2 – SAVEx 16.2 / SARVEx 07.2 – SARVEx 16.2 Control unit: electronic (MWG)
Table of contents
ACVExC 01.2 Non-Intrusive Modbus RTU
