2.
Push both lower discs with the symbols
(OPEN) and
(CLOSED) towards
each other. The disc with the arrow is thereby
is driven:
Figure 82: Setting position in CLOSED
3.
Move actuator to end position OPEN.
➥
The arrow
rotates in direction OPEN driving the indicator disc with symbol
(OPEN) until the actuator stops in position OPEN.
Figure 83: Operation in direction OPEN (left) and position OPEN (right)
4.
Check settings:
➥
The setting of the mechanical position indicator is correct, if the angle between
the symbols
(OPEN) and
(CLOSED) ranges between approx. 120° and
280°.
➥
If all three discs are turned at the same time, the indicator can be shifted in
steps of 15°. Individual shifts of 5° are possible.
➥
If the indicator is rotated too far (more than 280°) or if the angle is too small
(below 120°), adapt the gear stage setting to the actuator turns/stroke. Refer
to <Gear stage of the reduction gearing: test/set>.
10.2.2.
Gear stage of the reduction gearing: test/set
The test/setting is only required if the mechanical position indicator cannot be correctly
set.
73
SAVEx 07.2 – SAVEx 16.2 / SARVEx 07.2 – SARVEx 16.2 Control unit: electronic (MWG)
ACVExC 01.2 Non-Intrusive Modbus RTU
Commissioning (settings/options in the actuator)
