39
Troubleshooting
Problem
Possible Solution
Cannot turn on the Display
Unit
1.
Press and hold the Power button for at
least three (3) seconds.
2.
Make sure the power cord is properly
connected at both ends.
Cannot turn on the
Receiver/Transponder
1.
Press and hold the Power button for at
least three (3) seconds.
2.
Make sure the power cord is properly
connected at both ends.
Unable to obtain a reading
1.
Make sure the Aulisa sensor module(s
)
is
within 32.8 feet (10 meters) spherical
radius to the Receiver/Transponder.
2.
Verify the system’s wireless connection.
3.
Check the Display Unit for any alarms or
error messages.
The Display Unit is in Alarm
mode, but no audible alarms
can be heard.
1.
Wait for two (2) minutes and alarm tones
will automatically re-engage.
2.
Make sure no headphone is plugged in.
Cannot establish
system connection
1.
Make sure the Aulisa sensor module(s
)
is
within 32.8 feet (10 meters) spherical
radius to the Receiver/Transponder.
2.
Check Wi-Fi router settings
3.
Reset the Wi-Fi network for the Display Unit
and the Receiver/Transponder.
4.
Turn off the system and retry.
Refer to the Aulisa sensor module(s
)
Instructions for Use for additional
troubleshooting.
If these solutions do not correct the problem, please contact your distributor, or
contact Aulisa by going online at
CAUTION!!!
This system is a precision electronic instrument and must be repaired by
knowledgeable and specially trained Aulisa personnel only. Do not attempt to open the
case or repair the electronics.
Summary of Contents for Guardian Angel GA2000 Series
Page 5: ...4 Guide to Symbols...
Page 6: ...5...
