5.1.4 PIN code
Dial
#*#*3<PIN_CODE1>#<PIN_CODE2>
<PIN_CODE1>
Numeric field with a variable number of digits, minimum 4, maximum
8. After having entered the digits, type
#
(Number sign) to close the field
PIN_CODE1
in order
to divide it from the next field
PIN_CODE2
<PIN_CODE2>
Numeric field which shall validate
<PIN_CODE1>
. The setting is only
accepted if the two fields are the same.
Dial
#*#*3####
Typing a series of four
#
instead of the PIN digits, the non volatile
flash memory of C
EL
L
INE
®
is updated by the
FF.FF.FF.FF
. sequence. Command used to delete
a PIN which may be already available.
5.1.5 How to configure the request to dial tone
Dial
#*#*4<DIAL_TONE_TYPE>
<DIAL_TONE_TYPE>
Single numeric digit (
0
o
1
) specifying the type of the request to dial
tone which shall be set according to the following association:
0
International (Continuous tone)
1
Italian (ON-200ms OFF-200ms ON-600ms OFF-1s)
5.1.6 Sound level upon reception
Dial
#*#*5<VOICE_RX_LVL>
<VOICE_RX_LVL>
Single numeric digit (from 0 to 6) specifying the sound level upon
reception which shall be set:
0
Low level
6
High level.
5.1.7 CLI (Calling Line Identification) visualization for waiting call (2nd call)
Dial
#*#*6<CLI_2nd_CALL>
<CLI_2nd_CALL>
Single numeric digit (‘0’ or ‘1’) which communicates to the software
to send the CLI for the waiting call.
1
Function enabled.
0
Function disabled (default).
5.1.8 Polarity reverse
Dial
#*#*7<IDLE_POL><DIALLING_POL><RINGING_POL><ONLINE_POL>
<IDLE_POL>,<DIALLING_POL>, <RINGING_POL>,<ONLINE_POL>
are single numeric digit
parameters (‘0’ or ‘1’). They communicate to C
EL
L
INE
®
the polarity to maintain during the
specified states. 1 = positive, 0 = negative. Default values = 1,1,1,0 (pos., pos., pos., neg.)
72
C
EL
L
INE
®
AS-RS-AX-DX
USER MANUAL
© AUDIOTEL Engineering S.p.A.
AS
AX DX
RS
AS
AX DX
RS
AS
AX DX
RS
AS
AX DX
RS
AS
AX DX
RS
ENGLISH