Hardware Installation Manual
36
Document #: LTRT-41749
Mediant 4000B SBC
8.
Hold the chassis for support while the second person positions the chassis so that the
front-mounting brackets are flush against the front-rack posts and the holes of the
front-mounting brackets align with the holes on the front-rack posts.
Figure 4-11: Front-Mounting Brackets Flush and Aligned with Front-Rack Posts (60 cm)
Figure 4-12: Front-Mounting Brackets Flush and Aligned with Front-Rack Posts (80 cm)
9.
Hold the chassis in position while the second person secures the two front-mounting
brackets to the front posts, by finger-tightening 19-inch rack bolts (not supplied) to the
rack posts.
10.
Tighten the bolts on the front-mounting brackets.
11.
With a Philips screwdriver, tighten the screws securing the rear-mounting flanges to
the rear-mounting brackets.
Notes:
•
Make sure that all the mounting brackets are attached at the same level to the
mounting posts so that the chassis is supported in a horizontal position.
•
If the depth of the rack exceeds the maximum length of the adjustable rear-mounting
brackets, install an additional side rack post to accommodate the length of the rear-
mounting bracket.
Summary of Contents for Mediant 4000B SBC
Page 2: ......
