Session Border Controllers
29
Mediant 4000B SBC
Hardware Installation Manual
4. Mounting the Device
4
Mounting the Device
The device can be mounted in one of the following ways:
Placed on a desktop - see Section 'Desktop Mounting' on page
29
Installed in a standard, 19-inch rack - see Section ‘Rack Mounting' on page
30
Warning:
The side panels of the chassis where the air vents are located must remain
unobstructed to ensure adequate airflow and prevent overheating inside the
chassis.
Pay attention to wiring and cable routes to avoid blocking of the ventilation openings.
Avertissement :
Les panneaux latéraux du châssis où se trouvent les buses de
ventilation doivent être dégagés pour assurer un flux d’air adéquat et prévenir la
surchauffe à l’intérieur du châssis. Faites attention au câblage et aux chemins de câbles
pour éviter de bloquer les bouches d’aération.
4.1
Desktop Mounting
The device can be mounted horizontally on a flat surface. The device provides four anti-
slide rubber feet (supplied) that first need to be attached to its underside.
To attach the anti-slide rubber feet to the device:
1.
Flip the device over so that its underside faces up.
2.
Locate the four anti-slide grooves on the underside -- one on each corner.
Figure 4-1: Rubber Feet Locations
3.
Peel off the adhesive, anti-slide rubber feet (supplied) and stick one in each anti-slide
groove.
4.
Flip the device over again so that it rests on its underside with the rubber feet in
contact with the surface.
Summary of Contents for Mediant 4000B SBC
Page 2: ......
