AudioCodes Mediant 1000, Installation Manual

Page: 42 / 62

Installation Manual 42 Document #: LTRT-83505
Mediant 1000
7. For MGCP take the following steps:
a. In the ‘SDP Session Owner’ field, enter a name to the device (for example,
‘gateway1.com’). Ensure that the name you choose is the one that the Call Agent
is configured with to identify your device.
b. In the ‘Endpoint Naming Using Name Patterns’ field, enter an intuitive endpoint
prefix. Ensure that the endpoint prefix you choose is the one that the Call Agent
works with. In the ‘Endpoint Numbering Offset’ field, you can enter a value to
offset the numbers that represent the device's endpoints.
c. In the ‘Trunk Naming Using Name Patterns’ field, enter intuitive prefixes. Ensure
that the definitions you choose are the definitions that the Call Agent is configured
with to identify your device. In the ‘Trunk ID Offset’ field, you can enter a value to
offset the numbers that represent the device's trunks.
8. For MEGACO take the following steps:
a. In the ‘Physical Name Pattern’ field, enter an intuitive name to identify the device's
physical termination in the format: [name1]*[name2]*. The first asterisk represents
the number of the trunk; the second asterisk represents the number of the
endpoint. For example, ‘tgw/t*/c*’.
b. In the ‘Logical RTP Name Pattern’ field, enter an intuitive name to identify the
device's RTP termination in the format: [name]*. The asterisk represents an
internal identification assigned by the device to the RTP termination. For example,
'gw/rtp/*'.
9. Save your settings to the flash memory and reset the device (refer to 'Saving and
Resetting the Device' on page
45 ).
3.4 Enabling Channels and Configuring Call Routing
(Example)
This section provides an example for enabling the device's channels and for configuring Tel
(PSTN)-to-IP call routing. This includes assigning the channels a telephone number and
then routing calls (e.g., of dialed numbers with prefix 10) from these channels to a specific
IP destination (e.g., IP address 10.33.24.14).
¾
To enable channels and configure call routing:
1. Assign telephone numbers to endpoints or trunk channels, by performing the following:
a. Open the ‘Trunk Group Table’ page ( Configuration tab > Protocol
Configuration menu > Trunk Group submenu > Trunk Group ).
Figure 3-3: Enabling Channels in Trunk Group Table Page