DUST AND POLLEN FILTER: REPLACING
Removing
NOTE:
The dust and pollen filter consists of two identically constructed filter
elements. When installing, observe correct installation position (filter flow-
through direction is indicated with arrows).
Clean plenum chamber after replacing dust and pollen filter. Pay special
attention to area under air intake unit.
Clean dust and pollen filter installation duct in air conditioner before
installing new filter.
There are different versions of the dust and pollen filter and both filters
have different air resistance. Use the correct version. The control curve for
controlling fresh air fan V2 in the operating and display unit, the
Climatronic Control Module J255 , is adapted accordingly.
The filter insert without active charcoal insert (AKF filter insert) is installed
on vehicles with an operating and display unit, Climatronic Control Module
J255 "base" version ETKA. No Air Quality Sensors G238 are installed in
these vehicles.
The filter insert with active charcoal insert (AKF filter insert) is installed on
vehicles with an operating and display unit, Climatronic Control Module
J255 "comfort" version ETKA. Air Quality Sensors G238 are installed in
these vehicles.
NOTE:
Depending on vehicle equipment, it may be necessary on certain versions
(with certain special features, such as taxis or police cars) to remove the
glove compartment (eventually, certain other additional control modules
installed in this area will have to be removed.
On vehicles with right side steering, the dust and pollen filter must be
removed towards the left from the air conditioning unit, in contrast to
vehicles with left side steering. However, the rest of the work procedure is
the same.
2008 Audi A6 Quattro
Maintenance Maintenance Procedures
FIXYOURCAR
2:27:40 AM
Page 69
