Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Refer to
⇒ “5.1 A/C Compressor, Removing From Bracket“,
.
Note
♦
On 4 and 5 cylinder gasoline vehicles, the refrigerant lines are
accessible from the top. The center noise insulation does not
have to be removed on these vehicles.
♦
On vehicles with a 6 cylinder gasoline engine, for example,
refrigerant lines are not accessible from above. On vehicles
with this engine, center noise insulation does need to be re‐
moved.
♦
On vehicles, where the screws on the refrigerant line connec‐
tion are not accessible when the A/C compressor is installed,
remove the A/C compressor from the bracket (for example, on
3.2L MPI vehicles). Refer to
⇒ “5.1 A/C Compressor, Removing From Bracket“,
.
♦
Remove this bracket for vehicles in which the refrigerant lines
are secured by additional brackets.
– Remove bolts -A- and -D-.
– Disconnect refrigerant lines -B- and -E-.
Note
Close all open lines and connections on A/C compressor with
suitable caps (to prevent dirt and moisture from entering the sys‐
tem).
Installing
Installation is the reverse of removal, noting the following:
Audi TT 2007 ➤
Heating, Ventilation and Air Conditioning - Edition 01.2011
5. Removal and Installation
155
