Atwood SCALE-O-MATIC S302, Operation And Safety Manual

Page: 15 / 53

AM MFG. CO. MASTER MODEL:
DIV. OF ATWOOD CORP. S302
© 2011
S302_13 13 1/11
PRACTICE SAFETY FIRST:
ALWAYS DISCONNECT ELECTRICAL SERVICE WHEN CLEANING OR MAINTAINING THIS MACHINE, THUS
AVOIDING CHANCE OF SERIOUS INJURIES. MACHINES ARE NOT DANGEROUS IF COMMON SENSE IS
APPLIED AND THE INSTRUCTIONS ARE CAREFULLY FOLLOWED. THINK AND PRACTICE SAFETY FIRST...
GUIDE TO GENERAL MAINTENANCE
READ AND FOLLOW MAINTENANCE INSTRUCTIONS
TO HELP KEEP THE UNIT IN GOOD OPERATING CONDITION.
REFER TO OTHER MATERIALS RECEIVED WITH THE UNIT AND TO SERVICE BULLETINS FROM THE MANUFACTURER
FOR ADDITIONAL INSTRUCTIONS FOR PROPER MAINTENANCE AND SERVICE. REGULAR INSPECTIONS AND PROPER
MAINTENANCE ARE ESSENTIAL TO HELP PREVENT ACCIDENTS AND INJURIES.
THERE ARE (5) GREASE FITTINGS LOCATED ON THE ROCKER ARM
AND DIVIDER FRAME, (FIG. 1). THESE FITTINGS SHOULD BE
LUBRICATED BI-WEEKLY FOR OPTIMUM BEARING LIFE.
FOLLOW NORMAL CLEANING AND MAINTENANCE PROCEDURES
OUTLINED IN THIS MANUAL. FOR FURTHER ASSISTANCE CONTACT THE
A.M. MFG. SERVICE DEPARTMENT AT (800) 342-6744...
CAUTION:
REPLACE ANY DAMAGED OR MISSING SAFETY LABELS. THEY
ARE AVAILABLE FROM THE MANUFACTURER.
MAINTENANCE FOR THE SCALE-O-MATIC S302 ALWAYS BEGINS
WITH KEEPING THE MACHINE CLEAN. PROPER CLEANING
PROCEDURES CAN BE FOUND ON PAGES 8-12 OF THIS MANUAL.
STANDARD LONG TERM MAINTENANCE CONSISTS OF
LUBRICATING MAIN WEAR POINTS OF THE MACHINE WITH AN
ALL-PURPOSE SYNTHETIC BASE GREASE. A GREASE GUN WITH
A FLEXIBLE HOSE IS NEEDED.
WARNING:
BEFORE MAKING ANY INSPECTION, ADJUSTMENT OR REPAIR, BE CERTAIN POWER SOURCE IS
DISCONNECTED AND ALL MOVING PARTS ARE BLOCKED OUT TO PREVENT INJURY. WEAR PROTECTIVE
CLOTHING.
A. ALL WORKING SURFACES SHOULD BE CLEANED REGULARLY.
B. THE TABLE TOP AND OTHER WORKING SURFACES SHOULD BE CLEANED REGULARLY.
C. MAKE SURE THAT ALL FASTENERS ARE TIGHTENED SECURELY.
D. MAKE CERTAIN THAT ALL GUARDS AND COVERS ARE IN PLACE.
E. CHECK FOR WORN, DAMAGED OR MISSING PARTS INCLUDING BELTS, SAFETY GUARDS AND
PROTECTIVE COVERS.
F.
ON A DAILY BASIS, INSPECT THE UNIT AND CHECK TO BE CERTAIN THAT ALL SYSTEMS ARE
OPERATING NORMALLY. DETAILED INSPECTION AND TESTING PROCEDURES ARE SPECIFIED
FOR VARIOUS COMPONENTS AT REGULAR INTERVALS. SET UP A CHART AND ASSIGN
RESPONSIBILITY FOR THESE ITEMS.
NOTE:
INDICATES
GREASE
POINT
ALL RECOMMENDATIONS FOR MAINTENANCE, BASED
ON A 7 DAY, 8 HOUR PER DAY WORK SCHEDULE.