AM MFG. CO.
MASTER
MODEL:
DIV. OF ATWOOD CORP.
S302
© 2011
S302_12 12
1/11
GUIDE TO CLEANING
STEP 1
REMOVE DIVIDER SLIDE GUARD USING T-HANDLE
PROVIDED TO LOOSEN THE FRONT TWO NUTS ON GIB
BARS (1).
TO OPEN FRONT OF ROUNDER, GRASP BOTH
T-HANDLES (PART NO.
) AND TURN BOTH
OUTWARD (2). THIS WILL RELEASE THE FRONT OF THE
CABINET.
LOCATE THE SWIVEL LOCKING HANDLE (PART NO.
). (3) LIFT THIS HANDLE TO THE UPWARD
POSITION WHILE HOLDING THE ROUNDER DRUM FOR
STABILITY. NOW TILT THE ROUNDER ASSEMBLY
FORWARD (4).
REMOVE FUNNEL (PART SR135RA) (5).
REMOVE ROUNDER SCREW (SLOWLY) PART NO.
R122RA) (6).
REMOVE DRUM (PART NO. R117RA) (7).
REMOVE PLASTIC SEAL RING (PART NO.
) (8).
CLEAN THE FOUR (4) PARTS WITH WARM SOAPY
WATER. DO NOT USE ANY HARD ABRASIVE CLEANING
MATERIALS.
REMOVE EXCESS DOUGH FROM ROUNDER BASE
INSIDE OF MACHINE.
REASSEMBLE IN REVERSE OF DISASSEMBLY. MAKE
SURE TO REPLACE PLASTIC SEAL RING FIRST, SLIP
THE DRUM OVER THE ROUNDER BASE SO THAT THE
DRIVE SLOTS ARE LOCKED OVER THE DRIVE PINS IN
THE ROUNDER BASE.
CARE SHOULD BE TAKEN TO SEE THAT THE EXIT RAMP
ON THE SCREW IS FACING THE DISCHARGE END OF
THE MACHINE.
NOTE:
WHEN CLEANING THE ROUNDER DRUM,
THE WATER TEMPERATURE
MUST NOT EXCEED 190°
Summary of Contents for SCALE-O-MATIC S302
