3
ATTO Technology FibreBridge 3300D Installation and Operation Manual
2 ATTO FibreBridge supports diverse SAN needs
The ATTO FibreBridge
family of products provides a Fibre Channel-to-SCSI bridge available as a
Compact PCI board, a stand alone enclosure that can be fitted for rackmount integration, or a desktop
unit, depending on the model and your needs.
The ATTO FibreBridge family of products share
common configuration options and functions to
provide the most versatile connectivity options
available. Each product has been engineered to
address specific customer needs. New capabilities
are integrated into products throughout the
FibreBridge family as much as possible, requiring
only an upgrade of firmware to incorporate them
into your SAN (see Chapter 12). To make sure
you have the most up-to-date version of the
firmware, visit the ATTO Technology website,
www.attotech.com.
All ATTO FibreBridge models include full duplex
mode, Class 2 transfers and direct fabric connect
capabilities.
The FibreBridge 3300R includes one Fibre
Channel port and two SCSI ports. It may be
installed horizontally into a standard 19-inch
enclosure (see Chapter 3).
ATTO Technology FibreBridge software executes
from the Intel 80303, an integrated I960JT
processor and PCI-PCI bridge.
➔
128 MB SDRAM, capable of 800 MB/sec.
➔
Qlogic ISP3300 Fibre Channel controller
with a copper or optical SFP module
interface.
➔
LSI 53C1010 SCSI controller provides
interface with two Ultra 160 SCSI buses.
➔
Ethernet interface is a 10/100Base T
implemented with an Intel 82559ER
Ethernet controller accessible from the
RJ45 connector.
FibreBridge 3300R quick start instructions
The ATTO FibreBridge 3300 offers a variety of
ways to connect into a SAN. The following is a
quick start description:
1
Physically place the FibreBridge 3300 where
you want it, horizontally into a rack
enclosure. (See Chapter 3).
2
Connect SCSI devices to the FibreBridge.
(See Chapter 4)
3
Connect the FibreBridge to your SAN:
attach cables to the SFP Fibre Channel
interface on the FibreBridge. (See
Chapter 5)
4
Using ATTO BridgeTools, a graphical
interface utility enclosed with your
FibreBridge, connect to FibreBridge
services via the RS-232 serial port or serial
header, Ethernet, or in-band SCSI over Fibre
Channel. (See Chapter 6)
5
Map your devices to the Fibre Channel
ports. (See Chapter 8 and Chapter 7.1.8)
6
Boot the computers on the SAN and set up
the configuration for the devices connected
to the FibreBridge.
Summary of Contents for FibreBridge 3300R
Page 2: ......
