6
FibreBrid
g
e 3300R
3300 can be facing front. The mounting holes
on the “L”-bracket fit a standard 19-inch rack
using a centered 1.25-inch (31.7 mm) hole
pattern.
➔
The ATTO FibreBridge 3300R weighs about
10 pounds. Be careful when installing it a rack.
➔
Always stack the rack from the bottom up to
ensure a stable and safe rack.
➔
Minimum rack depth: 10 inches.
➔
Make sure the power requirements of the
ATTO FibreBridge 3300R plus the cumulative
power draw of the other equipment in the rack
do not overload the supply circuit and/or
wiring of the rack.
➔
Properly ground the FibreBridge 3300R to the
rack equipment. The earth ground connection
must be maintained when supply connection is
other than direct connection to the branch
circuit.
➔
Install the FibreBridge horizontally within the
rack so it does not reduce the air flow within
the rack. The maximum ambient temperature
for the ATTO FibreBridge 3300R should not
exceed 50° C.
Exhibit 3-1
Connector side of the ATTO FibreBridge 3300R.
Exhibit 3-2
ATTO FibreBridge 3300R board layout
Summary of Contents for FibreBridge 3300R
Page 2: ......
