21
ATTO Technology FibreBridge 3300D Installation and Operation Manual
7.1.4 Fibre Channel configuration commands
The Fibre Channel ports are configured with default settings but may be customized using CLI.
DispFcPortDB
Used to display the contents of the specified FC port’s internal port database which contains Fibre Channel addressing information for each FC
target device visible to the FibreBridge.
Action: none
Information: DispFcPortDB <fp>
Returns: Node name, 24-bit port ID, 8-bit internal loop ID of each FC device
FcAck0
Specifies whether ACK0 or ACK1 will be returned in response to a Class 2 FC data frame or sequence.
Limits: Enable sends ACK0 at the end of a sequence. Disable returns an ACK1 frame for each data frame.
Action: set FcAck0 [enabled | disabled]
Information: get FcAck0
SaveConfiguration
Returns: [fp] [fl] [sb] [st] [sl] [Online|Offline]
FcClass2
Specifies if the FibreBridge will support Fibre Channel Class 2 (multiplexed) service. The FibreBridge uses Class 3 service by default.
Limits: [enabled | disabled]
Default: Class 3 (DISABLED?)
Action: set FcClass2 [enabled | disabled]
Information: get FcClass2
SaveConfiguration
FcConnMode
Controls/reports the connection mode the FibreBridge uses when communication across a Fibre Channel network, either to an arbitrated loop (FC-
AL) when you select loop mode, or point-to-point when you choose ptp.
Limits: applies to all Fibre Channel ports
Default: loop
Actions: set FcConnMode [loop | ptp]
Information: get FcConnMode
SaveConfiguration
FcFairArb
Turns the Fibre Channel Arbitrated Loop (FC-AL) arbitration fairness on or off. When enabled, the FibreBridge follows the arbitration fairness
rules on the FC-AL.
Limits: applies to all Fibre Channel ports
Default: on, enabling arbitration fairness
Actions: setFcFairArb [enabled | disabled]
Information: getFcFairArb
SaveConfiguration
FcFullDuplex
When enabled, allows full duplex Fibre Channel communication between the FibreBridge and other Fibre Channel devices. Disable FcFullDuplex
results in half duplex mode.
Limits: applies to all Fibre Channel ports
Default: enabled
Actions: setFcFullDuplex [enabled | disabled]
Information: get FcFullDuplex
SaveConfiguration
FcHard
Used to enable or disable Fibre Channel hard address assignment. Under soft addressing, the FibreBridge loop address is assigned during loop
initialization. Use
FcHardAddress
(described below) if you enable hard addressing.
Limits: applies to all Fibre Channel ports
Default: enabled, or hard addressing
Actions: setFcHard [enabled | disabled]
Information: get FcHard
SaveConfiguration
FcHardAddress
Sets/displays the value used as the FC-AL hard address. This hexadecimal value represents the address the FibreBridge will try to use if hard
addressing is enabled. When an optional address is not present, the current value is displayed.
Default: 0 < = hard id < = 0x7d
Actions: set FcHard Address [fp |[address]]
Information: get FcHardAddress [fp]
SaveConfiguration
verbose return: Port n FcHardAddress = 0x01
Summary of Contents for FibreBridge 3300R
Page 2: ......
