Atten Gratten GA1483, User Manual

Page: 53 / 74

42
3-6 Configure LF output
During the procedures below, you can learn how to set the low-frequency
signal output with the following characteristics:
 Set the frequency as 1kHz.
 Set the output amplitude as 1Vp.
 Set the LF waveform as LF sweep frequency sine.
3-6-1 Configure LF output frequency and amplitude
1. Press PRESET .
2. Press the LF Out hard function key.
Thus, the LF output menu shall be opened.
3. Press the LF Output Freq soft function key, and input 1kHz.
Thus, the LF output frequency is set as 1kHz. 1.000kHz will appear below the
LF Output Freq soft function key.
4. Press the LF Out Amplitude soft function key, and input 1Vp.
Thus, the LF output amplitude is set as 1Vp. 1.000 Vp will appear below the LF
Out Amplitude soft function key.
3-6-2 Configure the waveform
1. Press the LF Out Waveform \ Swept-Sine .
Thus, sweep frequency sine wave output can be built, and a menu is opened,
and the weep parameters of the sweep frequency sine wave signals are
configured by the sweep frequency sine wave output.
2. Press the LF Out Start Freq soft function key, and input 100 Hz.