ATSG FORD 4R100, Manual

Page: 76 / 120

F 9
T P
- 7 A
2 6 2 - C
A
L-
20
Fo
rd
Fo
rd
59 "L ATE" DIRECT CLUTCH HOUSING ASSEMBLY
72 FORWARD CLUTCH HOUSING ASSEMBLY 59 "EARLY" DIRECT CLUTCH HOUSING ASSEMBLY
59
72
59
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
76
Copyright © 2003 ATSG Copyright © 2003 ATSG
NUMBER 8A
THRUST WASHER
Some Models
Only
Does Not Use
Number 8A
Thrust Washer
And Requires
Late Sun Shell
COMPONENT REBUILD
Forward And Direct Clutch Sub-Assemblies
1. We are once again showing you the difference
between the "Early" and "Late" direct clutch
housings in Figures 122 and 123, as this is the
last chance you will have to install the number
8A thrust washer, if you require one.
2. Place the completed direct clutch housing on a
flat work surface in the direction that is shown
in Figure 123.
3. Install the completed forward clutch housing
into the completed direct clutch housing by
rotating back and forth until fully seated, as
shown in Figure 123. 4. Install the number 9A thrust bearing into the
forward clutch housing in the direction shown
in Figure 124, with black side facing up.
5. Install the number 8C thrust washer onto the
forward ring gear and hub assembly, as shown
in Figure 125, and retain with Trans-Jel®.
6. Install forward ring gear and thrust washer into
forward clutch plates, as shown in Figure 126,
by rotating back and forth until fully seated.
Figure 122 Figure 123
Continued on Page 78.