ATSG FORD 4R100, Manual

Page: 111 / 120

6262
U P
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
111
Figure 196 Figure 195
Figure 194
Copyright © 2003 ATSG Copyright © 2003 ATSG
6262
U P
BOTTOM PAN
OIL FILTER
Copyright © 2003 ATSG
6262
U P
ACCUMULATOR
VALVE BODY
RETAINING NUTS (2)
RETAINING BOLTS (11)
Bottom Pan Components (Cont'd)
Continued on Page 112.
FINAL ASSEMBLY
12. Install the accumulator valve body, as shown in
Figure 194, install 11 retaining bolts and the
two nuts and hand tighten at this time.
Note: Refer to Valve Body Bolt Chart found
on Page 116 for proper locations.
13. Finish tightening the bolts and nuts on the
accumulator body (11 bolts, 2 nuts), main
control valve body (14 bolts, two nuts), the
solenoid body (9 bolts, one nut) and reinforcing
plate (3 bolts).
Note: Refer to Valve Body Bolt Chart found
on Page 116 for proper locations.
14. Torque all valve body bolts and nuts, as shown
in Figure 195 to: 9-11 N·m (80-100 in.lb.).
Note: Place the manual lever in the reverse
position and measure distance that manual
valve is protruding past the rear of the valve
body casting. It should be approximately
.050", as shown in Figure 195. If dimension
is not correct, replace the detent spring and
roller assembly with a "New" one.
15. Lubricate the seal on the new filter with small
amount of Trans-Jel®, and install new filter
into bore in oil pump, as shown in Figure 196.
Sn
ap-
On
Manual Valve should protrude .050" past
the rear of valve body casting, with the
manual lever in the reverse position.
MANUAL VALVE
P R N
2 D 1
Approx .050"